CONSTRUCTION PROCESS - DAY 1

BUILDING THE RAILS:  

     1.  Rule a line across the centre of the rails; this will be a guideline for the suspension/nails   
          (Figure 2).  
     2.  Next you need to work out the required spacing between the nails.
     3.  Mark a point on the left for a pin to hold the suspension.  
     4.  Measure 45mm to the right of the pin and mark a point for the first nail.  
     5.  Measure 38mm and mark a point for each consecutive nail (13 times) (Figure 3). 
     6.  Repeat this process for the second rail.  
     7.  For the 3^rd and 4^th rails measure 105mm to the right of the pin and mark a point for the 
          first nail.  Measure 38mm between consecutive #/♭ keys and 76mm for the breaks.

 8.  Using a 2.6mm drill bit, drill pilot holes as a guide for each nail (Figure 4).

 9.  Hammer a nail into each point (approx. 10mm into the timber) (Figure 5).

 10.   Mark each nail at 15mm (Figure 6).

 11.   Cut of excess nail with a dremmel (Figure 7).