CONSTUCTION PROCESS - DAY 7

ADDING THE BASE: 

  

    1.   Place frame on pine base (Figure 56) and trace around edges (Figure 57).

    2.  Cut base using bandsaw (Figure 58).
    3.  Measure and mark points for tacks (evenly spaced 10mm from the outside edge) 

         (Figure 59).

4.   Using a tack hammer nail in tacks (Figure 60 - 62).

   5.  Case complete! (Figure 63).

   6. Slide rails back into slots (Figure 64).

   7. Hammer in pins to secure suspension and trim off any extra tubing using scissors

       (Figure 65).